3D printer control board MKSBASE development board V1.2 motherboard Reprap Ramps1.4 compatible

3D printer control board MKSBASE development board V1.2 motherboard RepRap Ramps1.4 compatible

Availability: In stock

$47.35

Guaranteed genuine products from DIY3DP

Don't forget to checkout with DIY3DP Discount codes

Discount System
1

order $50+ receive 3% off -- use coupon DIY3DP03OFF50

2

order $100+ receive 5% off -- use coupon DIY3DP05OFF100

3

order $200+ receive 8% off -- use coupon DIY3DP08OFF200

4

order $300+ receive 12% off -- use coupon DIY3DP12OFF300

5

order $500+ receive 15% off -- use coupon DIY3DP15OFF500

Details

Details

3D printer control board MKSBASE development board V1.2 motherboard RepRap Ramps1.4 compatible Features: 1, a collection of all the functions on a single board to solve the complicated interfaces Ramps1.4 combination, problem-prone fault. 2, using 4982 as a motor drive, and a 4988 performance fairly, but with SOP package, the heat better. 3, the circuit board with high-quality 4-layer, and made a special heat treatment optimization; ramps are 2 shelves. 4, using high-quality MOSFET tube heat better. 5, using a dedicated power supply chip, support 12V-24V power input, the voltage converter chip Ramps solve the heating problem. 6, can accept 24V input, the same system power can heat the bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems. 7, the firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4. 8, control panel and can be connected directly Ramps1.4,2004LCD 12864LCD control panel.

Tags

Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Special Requirements

SPECIAL REQUIREMENTS

In case you need very special requirements: we recommend to contact us before purchasing

Write Your Own Review

Only registered users can write reviews. Please, log in or register